-
Is it possible to create reports based on clusters?
-
Are clusters defined at the Asset levels in a Facility?
-
What are the “Ownership groups” used for?
-
If for an existing well, would do an intervention in the future, will this be added in the production profile section, or should this be set up using a facility constraint?
-
Can PE information be copied from one Asset to the other?
-
How do I connect historic data to it’s forecast production potentials?
-
My well is set to be not in operation, but I want to toggle this on, but the slider for “Is in operation” is now greyed out. Why?
-
Could not run simulation, gets an error message saying: “One or more errors occurred“.
-
Could not run simulation, gets an error message referring to forecast well and drilling schedule.
-
Viewing results, having well by well, only when defining a wellbore?
-
How exactly does the distribution work, if we use the triangular P10, P90 distribution method, where do you see the effect of the distribution? We already have defined the low, high case and the base case, but where do we see the production
-
Is it possible to truncate data values below zero on a triangular distribution?
-
What data are we simulating on?
-
Do you need to save my changes when leaving a pForecast page?
-
Now we just ran a simulation. If I close the pForecast window, will I lose these results?
-
What data are we simulating on?
-
How do I import our pre-made decline-curve for production profiles?
-
If for an existing well, would do an intervention in the future, will this be added in the production profile section, or should this be set up using a facility constraint?